Followers

Thursday, July 14, 2011

Panzer III MG

The HO scale Roco Panzer III is a nice little model, but the front end is a bit bare, no bow mounted machine gun!



Head out to your local craft shop and buy some little tiny beads, about 1- 2 mm in diameter.



Then get a bit of stiff wire that is thin enough to go through the hole in the beads. I got my wire at an R/C airplane store. Take a couple beads with you to make sure the wire fits.





Using a pin vice, drill a tiny hole in the front of the Panzer III. It should be the same diameter as the wire.



Put a drop of model glue on the hole, insert the wire and slide a bead over the wire and flush against the front of the tank hull. Instant ball socket and machine gun. Project costs less than $5 and you can do about 100 Panzer IIIs.

6 comments:

El Senyor Verd said...

Good tip. Thank you.

peter said...

Very nice tip.

Greetings
Peter
http://peterscave.blogspot.com/

Erhntly said...

good idea :)

Anonymous said...

Simple and effective - perfect for that scale! Any thoughts on how to do it for 1/72 or 1/76?

Mike Bunkermeister Creek said...

El Senyor Verd, thanks for reading.

Peter, nice blog you have, I linked to it!

Mike Bunkermeister Creek said...

Erhntly, thanks!

easternfunker, just use larger beads. Also, if you have a surplus of machine guns, use the barrel from an MG 34 in 1/72nd scale. Remember, they did not use the MG 42 as a ball mounted machine gun on tanks.